Found this while sifting thru the interweb. Would not recommend searching on the term “bullethead stimulator” if you’re at work or haven’t updated your virus protection recently. Change color/size to suit your needs.
hook - Dai Riki 300 #10
thread - UTC 140 tan
tail - deer hair
rib - x-small wire copper
body - dubbing tan
body hackle - ginger (undersize by 2)
wing/head - deer hair
indicator - 1mm foam orange
Part 1
Mash barb/start thread at 3/4 mark
Clean, stack, measure (hook length + gap) a clump of deer hair; trim butts, tie in with 2 soft loops,
Pull tight keeping the hair on top of the hook, wrap thru the butts, trim, wrap to bend
Clean, stack, measure (gap width past bend - next time it’ll just be gap width at tie in; this one’s a little stalky) a smaller clump of deer hair; tie in/wrap to head butts/trim
This time with legs; shortened up the tail, too. Tyed here in skwala colors; not the olive green stuff that I’ve been using in the past but something closer to the ones I’ve been seeing, which is something like dirty motor oil (at least on the rivers I’ve found them on).
hook - Dai Riki 300 #10
thread - UTC 140 brown olive
tail - deer hair dyed dun
rib - x-small wire gold
body - dubbing brown
body hackle - barred rusty dun (undersize by 2)
wing/head - deer hair dyed dun
legs - Hedron Perfect Rubber brown
indicator - 1mm foam orange
