How To Make a Wing Burner - Volume 6, Week 16 Fly Angler's OnLine


Wing burners are available commercially through local
fly shops or catalogues, but sometimes a size or
particular shape you have in mind are not found. Or you
don’t want to wait to get one. Here is how to make your
own. The photos shown are for a tent caddis, with the
burner for a dragon fly wing shown at the end of the
article.

Start with a strip of brass, (available at hobby shops, or
hardware stores as shim stock.) — inch wide, .025 to .032
inch thick and about 8 and 1/4 inches long.

  1. Bend the strip in half and clamp it tightly with vise
    grips so the ends are even.

  2. With a hammer flatten the strip at the bend.

  1. Draw the shape you want on the open ends.

  1. Clamp the brass with the vise grips as shown below.

  1. With a saw and a file cut the brass to the desired
    shape while it is clamped in the vise grips. Smooth off
    the sharp edges with a file.

  1. The photo below shows a feather held in the burner.
    Use a lighter to burn the feather that is sticking out
    around the metal burner, but do NOT burn off the quill stem.

  1. This is the finished fly. The wing is about 1 1/4
    inches long.

  1. Caddis and the wing burner.

Here is a wing burner made by the same method for a Dragonfly:

Give it a try. ~ Dave


Please check out the Fly Tying Section, on the Bulletin Board, here at FAOL too.

If you have any questions, tips, or techniques; send them to
[FAOL]


Originally published January 18, 1998 on Fly Anglers Online by Dave.