I use a shot glass to mix my finish and a knitting needle to mix it. It is okay to wipe these off with isopropyl alcohol when I’m done or will it contaminate them for future use?
You mean there’s something else to use? If so, I’m in BIG trouble!! ![]()
That’s what I do Bruce… No trouble at all so far…Dan
Well, I didn’t know if the alcohol left residue that would affect my next batch of finish.
Thanks, Betty.
When My buddy reads this post I will be ridiculed.
Thanks, Dan
I use acetone, but I’m sure your method is just as effective.
kelly.
It gives that next shot of Jack a “stick to your ribs” quality, doesn’t it?
It sticks to your ribs and cleans you out at the same time.
Bruce,
I have a feeling when your Buddy reads this post “Buddy” will be totally thrilled that you’ve completed your build, and all went well!! I know I would be …:roll: ![]()
As far as the rod goes it’s at least good enough to show another rod builder. I bet you’re all getting tired of my trite questions. I’m sorry if that’s the case. I have less and less questions about building, but we never stop learning.
The Best To You All,
Bruce
Like the others have already said using acetone or isopropyl alcohol to clean them is fine you shouldn’t have any problems. I would suggest maybe switching to a normal plastic rod builders mixing cup though is I were you. That way you won’t have to clean the glass cup after every use, as well as you can leave the left over finish in the cup so you have check it to see if it’s dry. Then just toss it out and use a new one next time, they are pretty cheap to buy 200 of them.
Steve
Spot on, Steve!
kelly.
Steve’s right, I finally learned to stock up on mixing cups and disposable brushes. Cheaper by the dozens. I ruined a couple shot glasses first.