I have a second vice (Old Thompson A) set
up to the side when I tie flies. When I am
tying in Kyrstal Flash wings I leave all of
the flash material on the fly and place it
in the other vice. When the second fly is
ready for the wing, I then cut the flash and
move it to the second fly, where all the
ends are already even. This makes it easier
for me than picking the material up off the bench. ~ Rick Zieger
Please check out the Fly Tying Section, on the Bulletin Board, here at FAOL too.
If you have any questions, tips, or techniques; send them to
publisher@flyanglersonline.com
|