Found this on the Uni products site. Original had a Madam X half-head; I prefer standard bullet. Tied here as an October Caddis; change color/size to suit your needs.
hook - Dai Riki 300 #8
thread/rib - UTC 140 burnt orange
body - 1mm foam
shellback - 2mm foam rust
head/wing - deer hair
legs - medium rubber brown
indicator - 1mm foam orange
Part 1
Mash barb, start thread at head
Clean, stack, measure (hook length + gap) a clump of deer hair; trim butts, tie in with 2 soft loops, spin, trim butts
Tie in 2mm foam strip (3/4 gap width), wrap to bend
Tie in 1mm foam strip; wrap to head, tie off/trim
Brush top of body with Super Glue, pull shellback forward; tie down/trim
Push deer hair back, evenly distributing around shank
