Have a “Ross Flywater 3” reel and a piece of tippet got caught on the inside of the reel and wound tight around the inside of the drag disc. First was aware of it when I tried to strip more line for a cast and thought the drag had been somehow tightened way down. Tried to unwind the piece of tippet but it broke off and only about 1/4" is now sticking up from behind the disc. Not familar with removal of the mechanism and was wondering if it was possible to remove the cross pin? If so, what should be used to remove it or is it too tightly set to mess with it? Couldn’t seem to catch a hold of the tippet behind the disc with a small pointer as it’s wound pretty tightly. Any suggestions appreciated.
here is a link to some pdfs on the flywater reels. Many of the pdfs have blow up parts listing of the reels which should help. Check out the “changing direction of retrieve” ones.
Thanks for the suggestion; but, I already had looked at the 2007 “Flywater” pdf’s you left the link for and wasn’t sure that removing that “cross pin” in the illustration was the key to gaining access behind the “drag disc” so the tippet could be removed. Didn’t want to do something that might disable the mechanism. Couldn’t really tell if the spindle releases by unscrewing it or if it all depends on the “cross pin”. Reckon I need “Reel Repair and Maintenance For Dummies!”
if its not an expensive reel you could melt the tippet out of it with a soldering iron as long as no parts of the drag has been soldered togather itself… i did that on a martin reel once and still works just fine, didnt discolour the reel either…
If its the large arbor flywater, You need to remove the drag knob to free the drag disk and spindle. The pin is held in by the pressure that the drag knob exerts pulling the spindle and the pin against the drag knob.
You can carefully pull the drag knob cover off with a pair of pliers. I did the by gripping the cover with pair of pliers and pulling the cover straight off. The cover pops off exposing the screw, washers, and nuts that you can remove to free the spindle and drag disk. Don’t squeeze the drag cover too hard.
On the older standard arbor flywater, you need to pop the flat drag knob cover off.
Tailingloop is correct. This design is very similar to the old Gunnison reels. If you are reasonably mechanically inclined it should not be any trouble.
I’m just looking a the diagram, but I’m pretty sure in my instructions. You’ll need to carefully pry the “Drag Knob Cap” off (1), then unscrew the “Drag Knob Screw” (2) as much as it will go. Note - make sure to take notice of the initial position before unscrewing it; this could change the initial drag setting otherwise. I believe you should then be able to loosen the drag knob.
If that isn’t enough to access the tippet material, then you may need to take off the “Drag nut” (5) and loosen the knob further if possible. If that is not enough, you would then need to loosen the “Spindle nut” (7).At that point, the whole spindle can be removed from the reel, which should be sufficient.
However, I would think that once (5) is removed, you should be able to remove the cross pin and thus the drag disk, and should not need to remove (7).
Decided to try Bugman’s advice first and a few flicks of the old BIC seems to have done the trick. Line seems to be running pretty free now; so, thanks again for the suggestions.