Here is a tip I learned from a Fly Tyer article by Art Scheck on how to deal with slippery hairs (like squirrel tail) when tying hairwing streamers. The pattern is the Shushan Postmaster which uses squirrel tail for the wing. Below is the fly, just before the hairwing is tied in.
Use a soft loop to secure the hair bundle where you want it. Use 3-4 tight thread wraps to secure it in place. Make sure you hold the bundle of hair while securing it.
This is where the technique I learned from the Art Scheck article starts. Lift up about 1/3 of the hair bundle and take two tight thread wraps, pulling down and towards the hook point. This locks the hair bundle you pulled up into place.
Lift up the second third of hair and take two more tight thread wraps.
Finally, lift up the remainder of the hair, and again take two more thread wraps. Always angle the thread twoards the hook point.
Cut the hair butts at an angle, as seen in the photo.
Put a drop or two of head cement where you just cut the hair off. Let it soak for a couple seconds then finish the head as you normally would.
Thanks for the pics and tips. I usually dump half a bottle of Sally on the head instead of a couple drops as you suggest, but I really thin it down a lot to get more penetration.
A much simpler way, is to secure the hair wing to top of hook shank with 3 or 4 wraps and then take one tight wrap around just the hair wing. Trim the hair and finish wrapping the head area. No glue necessary. Pull as hard as you want the wing will not pull out.
Try using wolverine hair and you will see what works and what does not.
Tie in slippery hair backward and fold back into the right position. A soft loop or two will keep the bundle in exactly the right place. A little head varnish and waxing thread will help hold the thread wraps in place as you wrap over the bent section.
So Hap, if I am looking at this correctly, tie in the hair butt to the back of the hook, then fold over so the ends go over the front? I am trying to picture this. I assume you get a nice head out of this.
Thanks,
Mike
