The multi hi-tie Hedgehog wing conveniently fit within the segmented Rogue chassis. 1mm foam might be a bit thin for this application; may try it with standard 2mm.
hook ? Dai Riki 280 #6
thread/body - UTC 140 tan
body/head - 1mm foam tan
wing - deer hair
legs - medium rubber corn snake
indicator - 1mm foam orange
Part 1
fold foam strip (not quite gap width), trim rear at an angle to create tapered rear of body
fold, insert needle; mount needle in vise, start thread
pull foam forward, take a couple wraps of thread to create 1st segment
pull foam back, split the uprights with thread, take a few more wraps
create next segment