Results 1 to 1 of 1

Thread: Classic Fishing Rig

Threaded View

  1. #1
    Join Date
    Sep 2004
    Location
    ,Yosemite region
    Posts
    2,700

    Default Classic Fishing Rig

    Runs and tracks nicely down a country road.. All Rubber for fenders welts , doors , glass , vent window tracks and felts have all been replaced..The engine , compartment and under carriage is super clean and well kept. Stainless steel exhaust , muffler & tailpipeGas tank flushed clean / fuel gauge & speedometer rebuilt.** One door ding driver side lower hinge , over extended door still opens and closes but push button sticks when opening. Good to have it repaired eventually for mechanical and appearance reasons.---------- Idaho falls area , Starting serious offers at $ 8.500.00. Stephenmolcsan@gmail.com Samples of how clean it is:All rubber and felts replaced About the wood I used for the truck bed:Its green washed tong and grove apitong hardwood , use extensively in the industry for truck trailer beds.Its supported under with uni-struct spacers and fastened on the existing metal bed with recessed 3/8 brass ship bolts , locks and nuts drilled through and attached to the under bed ribbing.I also used it for the bed stakes supporting the crown and on the tailgate. The stuff is a very dense grainand harder than oak planking. Strong box goes with it , including the Kennedy box in the corner with alltools required for tune up , Timing light , Dwell meter and more. The truck is a labor of love all around. I want to keep the flag & pole as they were used with the truck during special military presentations over the years ,Final note of importance:Though not 100% original due to some wood enhancements that include a tailgate insert, rear bumper , bed crown and interior details to this otherwise all stock refurbished rig. All wood enhancements including the interior cab doors ,the kick-panels , the headliner ,the cab floor and , the exterior running board trim strips , Some of this not shown in these posted photo lots.as well as the tailgate are fastened directly to original components in such as way , so not to alter the integrity of truck as build. No metal screws ect..Thank you for looking !
    Last edited by Steve Molcsan; 02-27-2023 at 03:00 AM.
    Relaxed and now a Full Time Trout Bum, Est. 2024

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts