Graphite rod refinish?
Before I go and do something stupid - again - can I refinish a graphite rod? The finish is milky/scratchy in places and I would like to spiff it up. I plan on rewrapping the guides but want to get all my brain on the same page before I start.
Thanks for any advice.
Mike
Mike,
I dont' think there is any problem in doing that.
It shouldn't be too bad, especially since you are planning to re-wrap the rod.
Although I have never done it, I think that Permagloss is one of the preferred products for coating a blank.
I'd check into that.
Hope this helps.
Brian
Brian,
Thanks very much! I'll look into Permagloss for recoating. This is a rod that replaces a similar rod that went swimming on me! Any more advice is certainly welcome!
Mike
Would the permagloss used very lightly be enough to remove some light scratches on a graphite rod?
Posting Permissions
Reply With Quote