Classic Fishing Rig

https://www.flyanglersonline.com/bb/...9&d=1614307113https://www.flyanglersonline.com/bb/...6&d=1599184710https://www.flyanglersonline.com/bb/...4&d=1329343645Runs and tracks nicely down a country road.. All Rubber for fenders welts , doors , glass , vent window tracks and felts have all been replaced..The engine , compartment and under carriage is super clean and well kept. Stainless steel exhaust , muffler & tailpipeGas tank flushed clean / fuel gauge & speedometer rebuilt.** One door ding driver side lower hinge , over extended door still opens and closes but push button sticks when opening. Good to have it repaired eventually for mechanical and appearance reasons.---------- Idaho falls area , Starting serious offers at $ 8.500.00. Stephenmolcsan@gmail.com https://www.flyanglersonline.com/bb/...9&d=1515561299 Samples of how clean it is:https://www.flyanglersonline.com/bb/...6&d=1577939834https://www.flyanglersonline.com/bb/...1&d=1584247518All rubber and felts replacedhttps://www.flyanglersonline.com/bb/...3&d=1599188622 About the wood I used for the truck bed:Its green washed tong and grove apitong hardwood , use extensively in the industry for truck trailer beds.Its supported under with uni-struct spacers and fastened on the existing metal bed with recessed 3/8 brass ship bolts , locks and nuts drilled through and attached to the under bed ribbing.I also used it for the bed stakes supporting the crown and on the tailgate. The stuff is a very dense grainand harder than oak planking. Strong box goes with it , including the Kennedy box in the corner with alltools required for tune up , Timing light , Dwell meter and more. The truck is a labor of love all around. I want to keep the flag & pole as they were used with the truck during special military presentations over the years ,Final note of importance:Though not 100% original due to some wood enhancements that include a tailgate insert, rear bumper , bed crown and interior details to this otherwise all stock refurbished rig. All wood enhancements including the interior cab doors ,the kick-panels , the headliner ,the cab floor and , the exterior running board trim strips , Some of this not shown in these posted photo lots.as well as the tailgate are fastened directly to original components in such as way , so not to alter the integrity of truck as build. No metal screws ect..Thank you for looking !