Splitsville Caddis Emerger SBS

[ScottP]

Found a pic of a winged/hackled LaFontaine-like emerger doing an interweb search. Switched out the EHC wing for the split version; next one will utilize Congo Hair instead. My thanks to Messrs. LaFontaine, Quigley and Troth.




hook - Dai Riki 135 #14
thread - Uni 8/0 tan
gas bubble - Antron yarn
abdomen - Zelon dubbing hydropsyche
post - Danville Flymaster plus tan
hackle - grizzly
wing - deer hair
thorax - Zelon dubbing hydropsyche
front hackle - partridge


Part 1

mash barb, start thread; tie in antron, wrap down bend







dub thread/dub body to point above point










pull antron forward, surrounding body; push back a bit to create bubble and tie down










tie in loop







tie in hackle; hook loop onto gallows







wrap hackle up loop (length of thorax), and back to base; tie off/trim

[ScottP]

Part 2

stroke fibers back






clean, stack, measure (shank length) a clump of deer hair; trim to length, tie in, use thumbnail to splay








dub thorax






pull hackle forward thru wing, tie down




prep partridge; tie in by tip

[ScottP]

Part 3

wrap partridge, tie off/trim, whip finish, SHHAN








Regards,
Scott

[stream]

That look's like it should be a killer

[ScottP]

Splitsville Caddis Emerger (variation)







Congo Hair wing's a lot easier to install without excessive buildup in the thorax; makes a difference in smaller sizes. Ungulates around the world agree.


hook ? Dai Riki 135 #14
thread ? MFC 8/0 sand
gas bubble ? Antron yarn
abdomen ? Zelon dubbing hydropsyche
post ? UTC 140 grey brown
hackle ? grizzly
wing ? Congo Hair baitfish tan
thorax - Zelon dubbing hydropsyche
front hackle - partridge


Regards,
Scott