Great service on my Dan Vise from Al Beatty

[anglerdave]

For Christmas last year, my wife bought me a Dan Vise. Recently I noticed it was not rotating as freely as it should. I contacted Al and he told me to send it to him and he would either repair or replace it. I had it back in less than a week. He noticed that the jaws also would need to be replaced. This was due to an over tightening on my part. So he replaced them as well.

For the money I don't think you can beat this vise as far as rotary vises are concerned. And the service is some of the best I have experienced.

Thanks Al.

[Rick Z]

I didn't know that you tied that many flies. You mus thave really reffed on it.

Runnin' and duckin'.

Rick

[anglerdave]

I didn't know that you tied that many flies. You mus thave really reffed on it.

Runnin' and duckin'.

Rick

Rick

I have been tying up a bunch of woolly buggers for you. Ha!

[ducksterman]

Al...in his video explains how to adjust the jaws so there is not a tendency to over tighten

[anglerdave]

Al...in his video explains how to adjust the jaws so there is not a tendency to over tighten

Yes I know. But one tends to forget. Or in my case, over tighten.

[arend003]

Is the video available separately? I never got one when I bought my Dan vise at Orivs .
Tom

[ducksterman]

Is the video available separately? I never got one when I bought my Dan vise at Orivs .
Tom

There is a video that comes with the vise about setting it up...if you call Al I'm sure he would send you one...I can't remember if it covers what I said but probably does...I was referencing the one he has out on rotary tying.

[arend003]

Thanks will do
Tom

[TyroneFly]

Al also has a video on rotary tying techniques which covers adjusting the jaws as well. Great video by the way, but of course if you have ever seen any of Al's video series you would know that.

[Gardenfish]

good service pays off with a satisfied customer and that is excellent and virtually free advertising.