Very important to get a 50/50 mixture of the two bottles. as ASDO4 wrote. Use WHITE Post it notes or a paper pad to mix your components together. You just throw away a few sheets and it's all cleaned up. I usually lay out a 2 or 3 inch line side by side of each part that way you get a perfect 50/50 mixture. Then thoroughly mix the two parts together for 1 minute let set one minute to let the air bubbles settle out. then that gives you 2-3 minutes to work with it. Same formula used for rod building.

I have a guide friend who uses Loon UV Knot Sense for his Copper John's. He finds it easier to work with than 2-part epoxy. Also quicker.

Hope this helps,


------------------
John G.
Albuquerque, NM




[This message has been edited by Fishnfool (edited 18 September 2005).]