What is the best method for putting a reel seat onto the blank when there is a significant difference in the diameter of the hole in the reel seat compared to the blank? I've only built two rods so far and one of them the difference was pretty minor and I just used masking tape to form two arbors and filled it with epoxy. The other I was able to drill it out incrementally to get a pretty tight fit. But this is a larger difference and I'm not sure if the tape is a good route to go? I was looking at some graphite arbors online


17351098_10103811264986269_1401158141_n.jpg17407855_10103811267012209_433892432_o.jpg