A bit different look than with the traditional flanking flank feathers. This one's a bit unruly; I'll chalk that up to a thicker quill stem on the mallard (or I just screwed this one up). Tried a few options for the body (marabou, wound saddle feather) but liked the rabbit best; weighted shank optional.
hook - Mustad 9671 #4
thread - Danville 6/0 black
body - cross-cut rabbit yellow
wing - mallard flank
hackle - hen grizzly
Part 1
start thread, wrap back to the 1/3 mark; more a function of the length of the rabbit fur; I wanted the tips to end about a gap width past the bend (yrmv))
tie in zonker strip, brush shank with Super Glue; wrap to about the 3/4 mark, tie off/trim
prep mallard flank
tie in by tip, run scissors blade back along the top side to help the fibers lay down, wrap, tie off/trim