Hazel's Moose Hair Caddis SBS

[ScottP]

Was in the process of dyeing up some stuff and saw this one over on Speypages.


hook - Dai Riki 899 #8
thread - UTC 140 burnt orange/Danville 210 black
tail - moose body hair
rib - x-small copper wire
body - dubbing rusty orange
body hackle - grizzly dyed hot orange (undersize by 2)
throat - guinea dyed hot orange
wing - moose body hair


Part 1

mash barb, start thread; tie in rib and wrap to bend




clean, stack, measure (gap width at tie-in) a clump of moose body hair; tie in






dub thread/dub body to double wire






tie in hackle; wrap to tail






capture tip with wire, continue forward; helicopter end, cover with thread

[ScottP]

Part 2

tie in (folded) guinea feather by tip; wrap, tie off/trim






stroke fibers down/back, cover with thread






clean, stack, measure (tips to bend) a clump of moose body hair (switched to the heavier Flymaster because I popped off the UTC a couple times)




tie in/trim, whip finish, SHHAN








Regards,
Scott

[lastchance]

Hey Scott, is moose hard to work with the quantities required to make as wing?

[ScottP]

is moose hard to work with the quantities required to make as wing?

Bruce,

Moose hair I've worked with has been fairly stiff, which is great for tails; for wings, it's been more of a challenge. The Flymaster thread (210 denier?) I used did a good job of flairing the butts; I'd imagine something like GSP would work well, too.

Regards,
Scott