Foam and Dremel
Hey all you dremel bug fans! I just built a dremel lathe and have an upholstery needle for the mandrel. I'm using a very light touch, and I know what a light touch is on a lathe. Still, the foam slips around. The only reference on FAOL I could find about this was a suggestion to use a lighter touch. Anyone have another solution? Maybe rough up the mandrel? Super glue? tacky wax?
Thanks for any wisdom.
[This message has been edited by Diane (edited 04 February 2005).]
"If I'm not going to catch anything, then I 'd rather not catch anything on flies" ... Bob Lawless