Henry,

I tried to make such a tool...it was probably you in a previous thread where I saw it. I ran into problems...

...the single edged blades rode at a tilt and were unstable because of the thicker nonbladed side....I was using large washers that covered the whole blade and only exposed a corner of the blade....I was doing that to control the depth of the exposed blade so it wouldn't cut completely through the hide....see a recent thread...


...blades I had on hand and new blades I bought had only a tiny center hole...

Do you suspend your hides so you don't cut through hair?

There is a thread about double edged razor blades that I started...and one more recent on how to protect the rabbit hair....I think both have good info related to this topic.

How about a picture of your tool....