hook - Dai Riki 135 #14
thread - MFC 8/0 sand
rib - tying thread
body - dubbing tan
shellback - .5mm foam tan
legs - partridge
wing/head - Congo Hair tan
antennae - mallard dyed woodduck
Part 1
mash barb, start thread, wrap to bend; leave tag end long (for rib)
dub thread, dub body to point above point
taper a strip of foam (not quite gap width at widest point); tie in, letting tip extend gap width past bend
rib with tag end; tie off/trim
dub halfway to the hook eye
pull shellback forward/tie down
trim out center of partridge feather, tie in with fibers on either side; adjust length as necessary, tie off/trim