strike indicators
For anyone who uses strike indicators here's one I haven,t seen yet although it might be out there. Costs less than 4 cents and takes less than 30 seconds to make. Using an old flip flop punch out a half inch core. I used half inch copper pipe. Put a small hole through the middle (length wise) and then insert a plastic Q tip through the hole until some protrudes out of the other end. Use a lighter to melt the end of the Q tip until it curls back. With a wet finger flatten the end slightly. Do the same at the other end. Voila - done.indic2.jpgindic.jpg
They can also be used as popper. Just but the tippet through the hole and tie on a trailer hook with whatever materials on it you like.
Reply With Quote