HELP!
I've a question that maybe some of you experienced with 'tubes' can answer: Okay, so I've done the following: A)Cut the ends off a plastic Q-Tip and am left with about 2 inches of tube; B)Created a small 'collar' on one end by carefully using a lighter; C)Placed a heavy needle (it is about 5 inches long) into the tube with the 'collar' on the left side; Placed the left end of the needle into the jaws of the vise. Now the dilemma - Although very little, the space between the needle and tube is enough to enable the tube to spin around the needle which makes wrapping the thread just about impossible. Without the use of a specific tool for 'tying a tube fly', how do you keep the tube from spinning? Oh, I'm right handed. Anyone resemble this situation, lol?

Allan