Whole lotta foam going on here. I've seen it tied with/without wing; a little deer hair never hurts.


hook - Dai Riki 280 #8
thread - UTC 140 yellow
body - 2mm foam 3 layers (sheets glued together with spray adhesive and cut to width; colors of your choice)
wing - deer hair
legs - medium rubber brown
indicator - 1mm foam orange

Part 1

mash barb, wrap shank with thread (keep it rough so the foam has something to bite on)




taper the end of the foam (gap width)




push it down on the hook, indent shows where to make slit (just cut through bottom layer)






brush a little Super Glue, push foam down on shank and wrap down






cross over the back and start segmentation