+ Reply to Thread
Results 1 to 4 of 4

Thread: Formulaic Dubbing Twister

Hybrid View

  1. #1
    Join Date
    Jul 2004
    Location
    Ashburn, Virginia
    Posts
    3,598

    Default Formulaic Dubbing Twister

    I love Goduster's motorized dubbing brush maker http://www.flyanglersonline.com/bb/s...ng-brush-maker and really appreciate the workmanship that went into it and some of the great effects that can be created.
    Unfortunately, I rarely have a need for anything that substantial, meeting most of my requirements just using the split-thread method, letting the bobbin do double-duty as the dubbing twister. When I do need a full blown dubbing loop, I found a cool little gadget that, with a few small modifications, does a great job - a battery powered baby formula mixer.



    I cut off the end of the plastic wand and inserted a de-barbed, dulled-down Tiemco 200 hook (broke the eye off) into a pre-drilled hole with a little epoxy




    quick demo (just used some rabbit dubbing here; you can use other materials to make some interesting effects)

    create loop and insert dubbing




    insert hook in the end of the loop




    a couple quick blips (not sure of the rpms but it spins pretty quickly) and it's tight




    take your favorite dubbing teaser (a velcro'd popsicle stick works great) and rough it up a bit






    wrap the body, tie off and rough it up a little more as needed




    The mixer set me back about $6 and 15 minutes to put it together; you can find them at any of those baby superstores.


    Regards,
    Scott

  2. #2
    Join Date
    Aug 2010
    Location
    Avondale Arizona
    Posts
    173

    Default

    SAM_0708.jpgThanks for the Kudo's, unfortunately I do not do well with splitting thread, or normal dubbing, so I needed an alternative. Also it would take a ton of time for me to do the full body's like thes in the picture. I must admit you have come up with a pretty slick idea in my opinion.
    Last edited by Goduster; 04-03-2014 at 04:16 AM. Reason: Add

  3. #3
    Join Date
    Jun 2006
    Location
    NE Gwinnett Co., GA
    Posts
    4,801

    Default

    I learned about dubbing loops watch Leroy Hyatt on the KWSU series, "Fly Tying: The Angler's Art." Leroy uses a loop quite a bit for tight (less shaggy) dubbing as well as shaggy. I tie with monofilament a lot and it is very good with mono. I have a couple of homemade manual twisters that work well. The wire tip on the right twister makes adding the dubbing to the hook easier than the short heavier twister on the right. But they both work well.
    Attached Images Attached Images
    It's easier to fool people than to convince them that they have been fooled. Mark Twain

  4. #4

    Default

    Pretty slick, Scott!

    I like thread loops for any shaggy dubbing. I use it for scuds, shaggy thoraxes (w/o hackle), etc. I haven't felt the need for motorized assist, but do have a very simple homemade twister that I like very much (better than the purchased twister I had used previously). My homemade twister is simply a paper clip trimmed, reshaped, and glued into a bass fishing bullet sinker.
    IMG_20140213_070805636%u0025257E2.jpg

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts