Ok so finally the kingfisher is all done. dipped and ready to fish!!
- In finishing the Kingfisher I found that the furals had too much of a step to neatly wrap as is. What was done was a two part plumbers epoxy was used and shaped while keeping wet then wrapping after it dried and sanded.
- Another shot of the finished grip.
- this is a shot of the tiptop and mid section female
- A shot of the lettering and of the winding check from the original grip.
- this is the tip in the original rod holder.
- this is a shot of the but section in the rod holder
- This is the re covered rod holder that was original to the rod
- This is the new sock
- This is a closer view of the grain of the seat