Hello again all!

Well, I am waiting for my H&H 9'#4 kit to come in, and I have come up with a question. I am worried about trying to turn the blank by hand while putting epoxy on the wraps, and while they are drying by that matter. So I am thinking of getting a rod turner. Problem is, I am not wanting to make a lot of rods. In fact, after this kit, I may only build 1 - 3 more rods as gifts for family. I don't want spend a lot of moey on a factory turner just for 1 - 3 rods.

With that all in mind, has anyone built a homemade rod turner? Does anyone have any instructions on how to go about it? Is it worth it?

I am not trying to be "cheap", I just don't think $75 - $100 plus shipping is worth it for a max of 3 rods.

As always, all help and advise is GREATLY appreciated!!!

Sincerely,
Reg