-
Byron,
Go to any hardware store and get a piece of 1-1/2" PVC Tubing plus 2 end caps. Cut the tube to a length equal to the rod sections plus 2 or 3 inches. Glue one of the caps to one end. Sand the inside of the other cap and outside of the other end just a little and smoothly. The cap wil still fit snug but it'll be easier to remove when needed. Sand the exterior and spray paint if you desire. This rod case is just about indestructable and costs about $6. I just made one yesterday for a small rod I built. Had to buy a 10' tube, used 3', and have 7' left over. Guess I'll have to build a couple of more rods, lol.
Allan
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules