My Tenkara Bead Fly
I'm using Tenkara gear now, so thought I would share the images of a fly that I have adapted, which has been developed over a 10 year span of fishing my small home stream for 6 to 12 inch browns, rainbows and brookies. I tie these on a Daiichi 1260 hook mostly size 12 (very occasionally size 14 or 16) in three different colors; brown, olive and black. The beads are dubbed glass and along with the sparse tie ensure that the fly sinks well, but not to fast. The hackle is rabbit fur. I ran out of black rabbit for this shot so used another fur for that fly (not as good as rabbit). These are extremely effective for all styles of drift or retrieve and in most water types. Without a doubt the most effective single fly for my waters that I have ever used in 44 years of fly fishing, it was an easy choice for my one Tenkara fly. I think it would also work well nationwide.
Tenkara Bead Fly Brown.jpgTenkara Bead Fly Olive.jpgTenkara Bead Fly Black.jpg
Nice job, are those metal or plastic beads?
Sorry, I see there glass. I should have read first. Duhhhhh
Thanks Scott. They are a bit more fiddly to tie than your typical Tenkara fly, but not difficult. I can put together a dozen in pretty good time.
Is your dubbing loose like in a loop, then wrapped loosely around the beads? Nice look.
Thank you. Actually it's a rather unique method. At least I haven't seen it done before. I'll describe the process, which takes a bit of practice because certain steps have to be done quickly and accurately because of the super glue used to seal the beads and thread wraps. However, while you learn another type of cement could be used to slow down the process. But, nothing holds up like super glue, and you will end up with a super durable fly.
1. Flatten the hook barb and put the larger bead on the hook shank, wrapping a bit of thread behind it, and "liquid" super glue the bead and thread in place. The glue will flow between the bead and the hook shank. Use a tissue to soak up any excess glue.
2. Make a dubbing brush for the rabbit hair, very sparse, wind it on and whip finish, cut the thread carefully with an Xacto knife and finish with a tiny drop of super glue, deftly push the rabbit fur forward. If you wish you can put more thread wraps behind the fur hackle. I don't bother with this step.
3. Place the remaining small beads on the hook shank, but not too many.
4. Push the first small bead up to the rabbit hair and super glue in place. Again, the glue will flow into place.
5. Put a tiny bit of high tack wax on the hook shank behind the first small bead, being careful not to get the wax on the beads.
6. Touch a small wad of antron dubbing to the wax to release a sparse amount onto the wax. Push the next bead forward against the first bead.
7. Repeat with each remaining bead.
8. Wind a bit of thread behind the last bead as a tag and add a tiny dab of super glue.
The whole trick is to learn to be sparse with all materials, gentle and quick when needed throughout the process. Good luck and enjoy. Brant.