+ Reply to Thread
Results 1 to 10 of 10

Thread: Retain inscription after varnish

Hybrid View

  1. #1

    Default Retain inscription after varnish

    I'm starting to coat my boo blank with Helmsman Spar varnish but the handwritten inscription using a Micron 03 pen disappears. I tested this on the cork handle section (without the cork glued) of the rod so no harm done. What's the secret to retaining the inscription after varnishing?

  2. #2
    Join Date
    Apr 2007
    Location
    Four corner states
    Posts
    210

    Default

    disappears or washes away? I have not used a Micron 03 pen so I cannot be specific. If it is a latex or enamel you may need to let it dry more. Also clean the blank with some warm soap and water before the inscribing. I hope this is of some help.Again I have not used Micron 03 before.

  3. #3

    Default

    I use Micron pens for my rods without any problems. How are you applying the varnish? Maybe the finish wasn't de-glossed before signing? My technique is to rub some 0000 steel wool where I am going to sign to take the shine off, wash it down with Dawn and water, sign then dip. If you are using a brush for the varnish, give the ink a few hours to dry and use a sable brush to give the signature area a very light coat and let that dry before doing the rest of the rod.

  4. #4

    Default

    Thanks jklett. Perhaps I wasn't letting the micon ink "set in" before varnishing. I will lightly brush over the letttering first. I am applying the varnish with a balled up cloth. thanks again

  5. #5
    Join Date
    May 2001
    Location
    ann arbor mi, usa
    Posts
    383

    Default

    I think perhaps you ae rubbing it too much with the balled up cloth. I also use Micron pens. I usually let the lettering dry for a day and other hit it with a blow dryer to help set it. Like JKlett I 0000 steel wool first. and lightly brush on the varnish. If you are using the balled up cloth then I would do this. rough the surface, letter, hit with some heat, let dry 12 hrs, brush varnish over just the lettering, let that dry, then apply the rest of your finish.
    The only things we permanently keep, are those we give away-Waite Philips

  6. #6

    Default

    cheffy: appreciate your input. much thanks

+ Reply to Thread

Similar Threads

  1. Removing Rod varnish
    By Panman in forum Rod Building: Cane and Graphite
    Replies: 2
    Last Post: 08-28-2009, 06:28 PM
  2. More varnish questions
    By skondolf in forum Rod Building: Cane and Graphite
    Replies: 5
    Last Post: 07-08-2009, 09:35 AM
  3. Final varnish application - before or after wraps?
    By skondolf in forum Rod Building: Cane and Graphite
    Replies: 0
    Last Post: 04-08-2009, 12:22 PM
  4. varnish removal
    By bugman in forum Rod Building: Cane and Graphite
    Replies: 7
    Last Post: 09-25-2008, 01:55 AM
  5. Spar varnish?
    By Crow99 in forum Rod Building: Cane and Graphite
    Replies: 13
    Last Post: 01-15-2007, 06:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts