PADave
Check the winter 2010 copy of Fly Tyer magazine. It has a good article on making spoon flies. If you can not locate the magazine pm me and I will scan the article and send you a copy.
grumps
PADave
Check the winter 2010 copy of Fly Tyer magazine. It has a good article on making spoon flies. If you can not locate the magazine pm me and I will scan the article and send you a copy.
grumps
Bass_Bug I have tried the nail in the Dremel and that worked but I had trouble with the emery board shaping. It didnt seem to file the foam off very well. I will try your suggestions on the speed, thanks for the ideas.
I saw the post on the swap but got busy and didnt think I had time to do the swap. Guess I will pay closer attention next time. It sucks to get old.
iaflyfisher
Thanks iaflyfisher and grumps for pointing me in the right direction on the spoonfly!
Dave
A right emblem it may be, of the uncertain things of this world; that when men have sold them selves for them, they vanish into smoke. ~ William Bradford
I finally realized that Life is a metaphor for Fly Fishing.
iaflyfisher,
I found that when turning the soft craft foam that the actual shaping is more melting it that actually sanding it off. I've used toothpicks as a mandrel which actually holds fine, until you put too much pressure from the emery board, then the toothpicks break. After switching to the nail, problem solved. By the way the nail I'm using is a paneling nail. It's about the diameter of a standard round toothpick, but has small ring shanks in it that hold the foam great. If you put too much pressure on the foam, you can stop the foam and strip out the hole rending the body useless. Like anything else, it just takes a little practice.
Spring brook or Springbranch??
I especially liked the spoon fly. Great job!
All - it was Springbrook, north of Guthrie Center on Hwy 25 in the western part of Iowa.
Here is their website:
http://www.iowadnr.gov/springbrook/index.html
There is a DNR hatchery at Spring Branch but there is very little space to meet.
iaflyfisher