Grit for Building Reamers, Availability?

[Gandolf]

Hi All,

In my book on fly rod building, it discusses making reamers from sections of old fly rod, and coating them with grit. They then can be used to ream the cork grip to fit the blank.

The problem is that I have looked at various suppliers, and have not been able to find it. Where can it be obtained, and what is the best grit size?

Thanks and regards,

Gandolf

[rainbowchaser]

I went to the beach on Lake Michigan, coated my rod section with glue and rolled it in the sand. It works fine and I can always go back to recoat it some day if needed.

[Bass_Bug]

Should always keep Mud Hole on the top of the list for anything Rod building related.
http://www.mudhole.com/Shop-Our-Cata...e-Cutting-Grit

But I would also take a look at these grit-tape products. Much easier to make a reamer out of then by using lose grit. At least easier to make a consistent shaped reamer
http://www.jannsnetcraft.com/rod-bui...550200007.aspx
http://www.mudhole.com/Shop-Our-Cata...sive-25ft-Roll

[ldice]

It might be a little slower, but Woodcraft sells woodturners sandpaper in spools 1 inch wide that could be spiraled up to make your own reamer. I think a 50' rolls is under $10, and you have less chance of the rough grit from those reamers tearing out the cork.

[James Smith]

I tried the reamers and quite frankly I found them to be a real pain to use for any length of time not to mention that they wear out after a few handles. I found the easiest and fastest way for me was to take a rat-tail file, cut off the tang so that I could chuck it up in my hand drill and run it in reverse. It takes about 15 seconds to ream out the handle. The only thing I caution is that you MUST run the drill in reverse or the teeth on the file will really dig in and it will get stuck. (DAMHIK) I've been using the same file for the past four years and it works great. Just a thought...

Jim Smith

Jim Smith

[hardhat]

I have an assortment of rat tail files that i typically use for reaming out handles. The files need to cleaned as you go along, but I still found it to work best for me. I have put it the files into the drill before and found it to be a very quick process.
Another reason to run the drill in reverse is to prevent the file from digging in and pulling the cork handle into the chuck.

[Greg F]

I think the rat tail file is too short. I got a reamer making kit from Neal's fishing products and made a few reamers.
http://www.nealsfishingtackle.com/
It came with a bunch of rod sections, some eva handles, and a bag of grit. Glue on a handle, put epoxy on the blank and sprinkle with grit. Works great for years.