Here are the photos I have. Didn't take too many. They are the same as the first. Frankly, while the 3rd set of burners that I struggled with the silver solder on is functional, they are UGLY with a capital Gross.
I did not redo these as I believe the epoxy will hold up fine. If not, I will try something else. Didn't think about the JB Weld. I have some of that. The other set was simple to try the silver solder on as they had not been glued as yet. To redo these, I would either have to cut new shapes or grind the epoxy off so the solder or braze could stick.