ducksterman
Looks good. Sorry, I'm having computer problems, my screen isn't lighting up, so I'm sitting here with a small desk lamp shining on it so I can see and type. I did have to think about it. Though I'm glad I didn't have to drill a new hole in the vise.
Basically, you remove the arm from the vise, and unscrew the jaws. The jaws fit into the vise where the arm was. There's a half circle where the cam lever fits. You screw it in through the slit on the opposite side. Maybe you solved the problem by drilling a new hole, but I slide a heavy O-ring over the jaws and body back to the cam lever. This keeps pressure on the jaws when using the lever to open and tighten them.
I did try to move the tightening screw to the opposite side but I couldn't get it tightened the jaws. I'll have to take another shot at it but I think I'll just leave it where it is. Been doing it that way for too many years.