i've been reading as many posts as i can find, and primarily working from this site http://www.midcurrent.com/articles/g...ed_leader.aspx and this one http://globalflyfisher.com/fishbetter/henk/henk1.htm. my problem, which should probably be obvious, is that i don't know where to connect the paper clip at the bottom of the two pieces. i make everything loop around the dowels properly, then at the end i go one loop around the last two dowels, interlocking with the previous loop, and then one loop around just the last dowel...is that right? then i tie an overhand loop and hook it to a weight. so what i have is a loop around the final two dowels, a loop around the final dowel only, and a loop i've tied that is hooked to a weight. now, when i put a paper clip in to hook to the drill, does that go through the loop around the final dowel? or in the loop i've tied that has a weight in it? if i use the weight loop and start slipping the leader off the pegs it all falls apart, so i assume that either that is wrong, or i've done something wrong in the setup. if i put in in the loop around the final dowel then when i spin it i think it is going right, but the "tag" end with the weight just twists around my drill...what am i supposed to do with that? so basically, i think i'm setting the loops correctly on the jig, but i don't know how to take them off. i would LOVE to see a picture of the final peg, and the paper clip going through whatever part of the leader it goes through immediately after cutting off the spool and before putting it in the drill. thanks in advance, and links to what i should have found but haven't will work too.

cameron