hello,
I'am getting ready to start my second rod A Batson RX7 seven weight. The first rod I finished was a kit rod from cabelas, it was a two piece four weight. On the first rod I found the spine by rolling it back and forth at a 30 degree angle on the kitchen table. It was easy to do since it was a light rod and a two piece. The batson is a much heavier rod and a three piece. my question is what is the most accurate and easiest way to find the spine. In a thread this summer I read that some people don't even bother to find the spine anymore. Is this true???? If so I guess I will not even bother finding the spine what do you guys think??
thanks matt