So, I got the Elmer's Ultimate Glue being that they were just like the Gorrilla Glue. I liked it was made in the USA and a little lower priced to boot.
Previously, I have only wrapped maybe 1" long delams with epoxy I had. Today, I wrapped a couple 8" sections that were opened wide with pins and moistened to properly cure the glue. I read the instructions and understood that the glue would expand. 8" is a big section of OOOZing glue and I'm a little concerned about how to remove this stuff after it's cured. Mfr. recommendation in scraping and sanding. I opted not to remove excess while partly wet because I figured a thin coat of cured glue would be hard to scrape off than big chunks. The sanding part really worries me. Any thought or "been there" experience shared would easy my blood pressure.