Search:

Type: Posts; User: Baithog

Search: Search took 0.01 seconds.

  1. Thread: flamed bamboo?

    by Baithog
    Replies
    8
    Views
    11,325

    On the other hand, I seldom flame a rod. IMHO It...

    On the other hand, I seldom flame a rod. IMHO It doesn't make much sense to me to work hard to preserve as much of the power fibers as possible when you've turned the strongest outer ones to carbon....
  2. Replies
    21
    Views
    15,250

    John's passing was a shock to a lot of the bamboo...

    John's passing was a shock to a lot of the bamboo rod makers. He was a much respected member of our community. It is sad that John isn't here to make it right for you. You might want to contact his...
  3. Replies
    14
    Views
    12,313

    Bad eyes and bad fingers make them little flies a...

    Bad eyes and bad fingers make them little flies a real pain. I take a variety of pre-tied with me, but sometimes you gotta tie one in the middle of the river. I resort to the Buzz Bomb knot. you tie...
  4. Replies
    8
    Views
    9,899

    Cross some fingers. If'n we get much more rain,...

    Cross some fingers. If'n we get much more rain, we're gonna change its name to the Big Flooded Red.

    Larry
  5. Replies
    15
    Views
    10,787

    Its obvious that most of you have never had the...

    Its obvious that most of you have never had the dubious pleasure of trying to fish for salmon in Washington state. Reading the rules in the nearly half inch thick 8 1/2 by 11 regulation book does not...
  6. Replies
    10
    Views
    14,211

    Most of the seat companies sell the parts to roll...

    Most of the seat companies sell the parts to roll your own, if you want something that looks standard. If you want truly custom, then turn your own from 6061 aluminum, or get drawn cups from...
  7. Replies
    19
    Views
    14,284

    I have 2 of them and agree that they are not the...

    I have 2 of them and agree that they are not the usual pieces of junk. I switched the spring clutch over just to see if it could be done. Nothing is under sproing level pressure. The conversion was...
  8. Thread: Spar Varnish

    by Baithog
    Replies
    26
    Views
    21,906

    How To Do It

    The reason that the commercial builders went to the catalyzed coatings was time. To get a translucent whipping on a guide is quite time consuming. First comes the the secret sauce, which can be as...
  9. Thread: Spar Varnish

    by Baithog
    Replies
    26
    Views
    21,906

    d

    I don't get by here as much as I used to, but I ran across this discussion and find the thoughts interesting. I'm not sure how Dave is getting the football effect, but he may be using size A nylon,...
  10. Replies
    14
    Views
    10,693

    Toluene is not the same as Xylene. Acetone is...

    Toluene is not the same as Xylene.

    Acetone is not a carcinogen or a mutagen, according to the EPA (last revised in '03).

    Lacquer thinner is no longer acetone, it is usually Toluene and Ethyl...
  11. Replies
    18
    Views
    16,228

    I have been using the Loon water based cement...

    I have been using the Loon water based cement this winter. An incident with a bottle of solvent based cement in my lap got me looking for something I could clean up without destroying my liver (or...
  12. Replies
    33
    Views
    16,972

    I suppose that one could ask the same question...

    I suppose that one could ask the same question about tying flies or building rods. There is cost effective hardware available that will do a passable job. I've used knotless and they work. I prefer...
  13. Thread: Fly line size

    by Baithog
    Replies
    2
    Views
    4,860

    I have a flash that I inherited from my father....

    I have a flash that I inherited from my father. It's taken a long time to decide that it was meant to be used. I read on a bamboo board that they are probably a 6-wt. I measured mine with the CCS and...
Results 1 to 13 of 13