Re: wrapping female ferrules
You just need to wrap the female portion of the ferrule like you were putting on a guide. Get the thread as close to the end as you can. Rule of thumb is the wrap should be 2 times the diameter of the ferrule, but you should check with the manufacturer to see if they have requirement to keep the warranty valid. There is one manufacturer who doesn't require ferrule wraps, but I like to see them just to be safe.
Re: wrapping female ferrules
Be careful that you don't wrap too tightly , or you might not get the male fully engaged .
Re: wrapping female ferrules
I tie my female ferrules while engaged with the male section. I'm not sure that you can tie the wraps so tight as to compress the tube. I've not heard of that happening.
Joe
Re: wrapping female ferrules
Joe,
Yep, it has been known to happen. Snug, but not tight, kind of like the guides. I recall one guy who wrapped like you do with the ferrule assembled, and ended up cutting off the wrap to get the rod back apart. It might not be as much of an issue with the new generation rods/ferrules, but it is something to be check before the finish goes on. Better safe than sorry.
Greg
Re: wrapping female ferrules
Thanks for all the advice .. got the kit now to ream out the grip and get started will let all know how it goes ..
thanks again
tom
Re: wrapping female ferrules
Joe, it sure can happen, voice of experience addressing that one, lol. I always wrap with the sections mated, makes it much easier to wrap the ferrules that way, but I only use enough tension to keep the thread in place and to snug the tags. Too, I have heard of people wrapping graphite or fiberglass so tight that it compressed the blank to the point that it broke, haven't done that one but know a couple of folks that have.
Some manufacturers don't even require wrapping of the ferrules on their blanks but I always do as that is a very high stress point.