Printable View
The Lord said "ask and you shall receive" so here it goes...
I need a new fly vise...a rotary would be great - but something that's simply dependable and that hold a hook tight is more important to me at this point. Don't mind paying for it either, just don't have much to spend on one right now. I had a "starter vise" that I have wore the jaws out on. So, if anyone has a good one hanging around collecting dust let me know. Thanks and happy fishing!
contact: morgan.appraisals@gmail.com
Welcome to FAOL.
a danvise looks like what you need, it is a fantastic vise for a bargain price you can get them on eBay new for less than most rotaries used. If that is too much for your budget let us know how low you need to go.
Eric
hook and hackle, a site sponsor, carries a rotary vise for under $60. check them out!
http://www.hookhack.com/vises.html
The H&H EZ Rotary is a decent vise in my opinion unless your going to be tying a LOT of flies..the knob adjustments will wear your fingers raw but no more so than any other knob/non-cam vises.
Other than that, I am happy with the vise all the way...add the bobin holder in order to use the rotary function and your good to go.
I am going to eventually modify the knobs on the jaws by simply notching them and adding a shrt piece of ridgid bar to them to allow for leverage when turning...should be an easy, 15 minute job at best when I finally get annoyed enough at grippng those little knobs.
You'll get a huge range of opinions on this one. :)
Let me add my 2 cents:
A few months back I switched from a starter vise to a Regal. It rotates, but it's not "true" rotary on the shank-axis, if that's what you're looking for.
For me, it's perfect. Rock-solid grip, and allows me to tie a #22 dry and switch to a #2 streamer with no adjustment.
or head on down to home depot or lowes or your local hardware store and get a thumb screw to replace the original one.Quote:
Originally Posted by brhoff
http://www.instockfasteners.com/IMAG...00500-P-21.jpg
Exactly the idea Normand just haven't matched the thread yet.
Or you can also take an old Allen wrench and expoy or JB weld it into the hex head and make a "handle"! Good vise for the price, too.