How can I repair a rod that has been broken about 6-7 in. from the tip top?
Thanks
LilJoehttp://www.flyanglersonline.com/bb/i...cons/icon5.gif
Printable View
How can I repair a rod that has been broken about 6-7 in. from the tip top?
Thanks
LilJoehttp://www.flyanglersonline.com/bb/i...cons/icon5.gif
The easiest fix that may or may not work to your satisfaction is to attach a tip top at the end of the now shortened rod tip and see how it casts.
The best way would be to replace the whole section.
Barring that you need to find a piece of fiberglass (not graphite) rod of about 2inches that would fit tight inside the break
Check the fit, then cut the piece to size. Epoxy the bottom end and slip it into the section from the fat side and pull it up tight.
Then epoxy the top end of the fiberglass and fit the broken sections together
That whole area will need to be wrapped with thread to strengthen and coated with rod finish
It's not as hard as you'd think and the rod will be as good as new
I've fixed a couple of my rods this way and you wouldn't know the difference
the same as dudley except remove the tip top, slide the repair tube over the tip, fit it tight, then fit the bottom. should fit 1 to 1.5" above and below the break. when satisfactorily fit place epoxy inside the tube, slide over the tip until tight, wipe epoxy from broken tip section, place epoxy inside repair tube, fit bottom.
Hi LilJoe,
Please don't take this the wrong way. I'm really not trying to rub salt in the wound. I'm just one of those obnoxiously curious people who has to ask the guy with the cast on his arm, "How did you do it?" So, that being said, how did you do it? 8T :)
My son broke the tip section on his custom rod and the fellow who built the rod for him repaired it in much the same way as is being described here. Inserted a piece of fibreglass, glued the sections and finished with thread wraps. Other than thread wraps with no guide or ferrule, it looks like it's part of the rod and should be there.
Seems to work just as well as the rod did before the break. All was wel lin the universe.
Jeff
I like to use an insert, rather than a sleeve. It's a cleaner look when finished, and should hold up well that close to the tip. Essentially you're creating a spigot ferrule, but glueing both ends. I used a solid graphite rod that is sold at a model airplane shop. They have them in mm increments, so you can find something close and sand it to the right diameter. I repaired a 2wt this way and it still casts beautifully. There is a slight flat spot in the flex, of course, but it isn't something I notice while fishing. You'll have a flat spot with a sleeve as well.
The reason to use a fiberglass splice rater than a graphite splice is that the fiberglass flexes more than graphite and is less likely to create the flat spot. Graphite will stiffen the rod, stressing it above and below the blank creating two potential points of failure.