Carnage Hopper (gallows variation) SBS
http://i1302.photobucket.com/albums/...psxvmdko6n.jpg
Switched to 20lb mono for the core; after a few mis-fires, came up with an easier way to wrap the foam body, adding a bit of bulk as well. Normally for bulletheads, I tie the ungulate hair in first but it got in the way of the body sequence; as long as you leave sufficient room up front, it's easy enough to spin a proper head. Tie an underwing if you want - turkey feather, yarn, foam, landsacpe fabric, etc; I haven't found any fish that really care so I leave them off. Change colors/sizes to suit your needs.
hook - Dai Riki 135 #8
thread - UTC 140 tan
body - 2mm foam tan
wing/head - deer hair
legs - medium rubber cornsnake
indicator - 1mm foam orange
Part 1
put a loop in the end of a piece of mono
http://i1302.photobucket.com/albums/...psjpts9yxp.jpg
mash barb, start thread, tie in the mono
http://i1302.photobucket.com/albums/...psrktt5xbl.jpg
tie in a tapered strip of foam; hook the mono on the gallows
http://i1302.photobucket.com/albums/...ps4j5cwznh.jpg
brush Super Glue on the mono; wrap the foam up the core (use a bit of tension)
http://i1302.photobucket.com/albums/...psbr8gkeqb.jpg
http://i1302.photobucket.com/albums/...psdixpldw4.jpg
brush on a little more glue and wrap back down; finish with a turn or two on the hook shank; tie off/trim
http://i1302.photobucket.com/albums/...psrgwxi7hn.jpg
trim away mono
http://i1302.photobucket.com/albums/...psfpt6acdu.jpg
clean, stack, measure (body length) a clump of deer hair
http://i1302.photobucket.com/albums/...psxiraekdc.jpg
